WECO TS-100 Elevator Door Sensor – Installation Guide

## Installation Guide

This guide provides step-by-step instructions for installing the WECO TS-100 elevator door sensor.

## Step 1: Preparation

Before beginning installation, ensure you have the following tools:
– Phillips head screwdriver
– Measuring tape
– Level
– Drill with 6mm bit
– Wire strippers

## Step 2: Mount the Sensor

1. Position the sensor bracket at the top center of the elevator door frame
2. Use the level to ensure it is perfectly horizontal
3. Mark the mounting holes with a pencil
4. Drill pilot holes at the marked positions
5. Secure the bracket using the provided screws

## Step 3: Connect the Wiring

Connection diagram:

| Wire Color | Connection |
|————|———–|
| Red | 24V DC Power |
| Black | Ground |
| Yellow | RS-485 A |
| Green | RS-485 B |

## Step 4: Configure Settings

Access the configuration menu through the sensor web interface.

## Step 5: Test Operation

1. Close the elevator door
2. Wave your hand in the doorway
3. Verify sensor LED indicators
4. Run 20 complete door cycles

## Troubleshooting

| Issue | Solution |
|——-|———-|
| Door does not reverse | Check power connection |
| False triggers | Reduce sensitivity |
| No LED indicator | Verify 24V DC power supply |

For technical support contact WECO today.